The Ground Support System is a system manufactured with the purpose of providing a lifting medium for a variety of Topfuture Spigot trusses ranging from TF34 ,TF44,TF54 through to heavy duty truss. Included top section, sleeve block, ground support base, brace, electric motor etc.
Top Section
Top Section for electric motor & manual chain hoist, accepts the chain from the chain hoist which is run over the top of the roller beam and back down to the other side of the sleeve block. Model for TF34, TF44, TF54.
Sleeve Block
Sleeve Block is the interface between the truss rig and the towers. It is
designed to create a half-spigot joint between the truss grid and the towers by using 16 heavy duty wheels to guide the rig up each tower. Model for TF34, TF44, TF54.
Steel Base
The Steel Base of the tower has four adjustable screw jack to enable leveling of the tower. The base also incorporates 4 heavy castors which allows the whole rig to be accurately positioned before the tower is raised. Once the tower system is ready to be raised, all the screw jacks must be adjusted evenly and must take the load off the ball castors.
Hinge Section
The hinge section is designed to allow the towers to be assembled horizontally at truss top level before being swung and locked in the vertical operating position.
Outrigger and Brace
Outrigger and Brace sets are required when using less than 3 towers. These are designed to provide stability and rigidity to single or two tower systems.
Electric Motor
Capacity :500KG, 1000KG, 2000KG
Controller: Single controller or 4 channal, 8 channal, 16 channal.
Chain Length: 25m
Hoisting Speed: 3.2m/ min
Power Cable Length: 20m
Waterproof: IP67
Power 3-Phase: 220V 380V, 450V
Chain Bag: Avalable
Packing: Wooden Box or Flight Case
Electric Motor Controller
Power 3-Phase: 220V 380V, 450V
Channal: 4 channal, 8 channal, 16 channal.
Packing: Flight Case
